Loading 3D model… large boards can take a moment.
AVR Fuse Rescue Shield based on Arduino-based AVR High Voltage Programmer by Jeff Keyzer W6OHM aka @mightyohm.
While working on a new prototype for my GPS module for Yaesu VX-8DR/DE transceivers, I made some newbie errors burning incorrect fuses into ATmega328P microcontrollers and bricked them. After some research I found MightyOhm's High Voltage Programmer which could bring them back to life. His programmer was designed as Arduino shield thus I could use the Arduino Uno board I already had. In my project I used MightOhm's schematics with minor changes and his Arduino code as is.
I made this device for recovering ATmega328P chips. It may be compatible with other ATmega's, but you have to check the compatibility before you try. This shield uses high voltage which may damage your microcontroller.
The schematics are almost the same as the original MightyOhm's. Two minor changes are:
The shield requires external power supply of 12 to 16V. Unregulated power source will work fine.
The PCB was designed using KiCAD software. As it was meant to be produced at home I designed it as single layer board. There are some front side tracks in the design which were replaced by jumper wires in the real PCB. Toner Transfer method was used to transfer the drawings to copper and front side.
Print version: avr_frs_pcb.pdf
Print version: avr_frs-silk.pdf
MightyOhm's original Arduino code is used without any modifications.
Correctly assembled device requires no alignment.
You are more than welcome to contact me with any questions, suggestions or propositions regarding this project. You can:
If you like this project, or found here some useful information and want to say thanks, or encourage me to do more, you can buy me a coffee!
You can aslo make a donation with PayPal:
73 de 4X1MD
No comments yet. Be the first to ask about this board.