Soldering Sponge Automatic Water Dispenser

About

This is an automatic soldering sponge water dispenser. I got tired of the soldering sponge drying out, so I built an automatic water dispenser to “water” it. The dispenser uses a sensor to measure the resistance of the sponge. If the sponge dries out too much, the resistance goes up, the microcontroller detects it and turns on the pump.

Here you can find all the files related to the Soldering Sponge Automatic Water Dispenser build:

• Case 3D Files
• Firmware for the Attiny45
• KiCad Files

For more information about the project, see my blog posts: Soldering Sponge Automatic Water Dispenser

Build