Loading 3D model… large boards can take a moment.
The zwerg is a 3x6 (well technically 4x6 I guess?) split ortholinear 40% keyboard. It's heavily inspired by RGBKB.net's Sol 3 of which I own two and absolutely adore.
[!Warning]
Please note that this design only works with a slim usb-c cable/connector (5.5mm).
KLE: https://www.keyboard-layout-editor.com/#/gists/f58560b496cb75689321efaddc96187e
The typing and tenting angle can be freely adjusted in the OpenSCAD file. I printed mine with a typing angle of 2° and tenting of 5°.
Building this keyboard is pretty straight forward I think. The only thing you need to look out for is that you solder all components on the same side (same goes for the mirrored pcb). Don't over tighten the screw that attaches the pcb to the case, it's supposed be screwed in lightly.
This keyboard is powered by qmk firmware, see here. Use the reset buttons on the Gemini for flashing the keyboard.
No comments yet. Be the first to ask about this board.