keeb-dreaming

Build a 68% keyboard pcb and case

Assembled keyboard (bought the caps and switches):

Features

• USB-C
• Volume knob + mute button
• Compression fit of pcb with case, no fasteners needed

PCB

• Learned from https://wiki.ai03.com/books/pcb-design/chapter/pcb-designer-guide
• Use KiCAD to edit the schematics and pcb design

Firmware

• Copy this folder into the QMK repository's keyboards folder
• Use the QMK MSYS terminal tool and run qmk compile -kb zap -km default
• Alternatively, if you have a c compiler and make installed, run make zap

Flashing

• make zap:default:flash
• If that does not work try power cycling/resetting while shorting the BOOT0 pin to ground (exposed on the PCB, feel free to solder a switch on it).
• Use the STM32 programmer for further debugging and validating.

Case

• In the picture above is this case, 3D printed, modeled using SolidWorks (free-trial)
• A layered version is also in the case/layered folder