Loading 3D model… large boards can take a moment.
Arcade Coin Mechanism Interface
This is a simple little interface board to connect a 12V arcade coin mechanism to a 5V interface board (e.g. the Ultimarc I-Pac). The board supports connecting 2x 12V coin mechanism, and 1x 12V Coin Counter.
So - Where to get one?
I don't sell these! The design is Open Source. I upload my designs to OSH Park and have them manafacture the board for me, I've included a link below.
(I do not earn commission etc from OSH Park if you order from them)
But, What does it look like?
What parts will I need?
- The PCB itself (See below)
- 2x JST-XH 4 pin sockets
- 2x JST-XH 2 pin sockets
- 1x JST-XH 2 pin sockets
- 2x 5V Zener Diodes
I use JST-XH sockets everywhere, but any socket with a 2.54mm pitch and approximatly the same outside will do just fine.
How do I assemble it?
- Place the 2x Zener Diodes into their spots (D1 and D2) and solder in place. Ensure the stripe on the diode is on the correct side - match the orientation shown on the PCB itself.
- Place the JST-XH connectors.
- Pay attention to the orientation, the markings on the PCB show which direction the socket should go, look at the slots in the connector. If using a different connector type, just be consistent in which way you orient the connectors!
- Place all connectors at once, then carefully turn the board upside down and allow it to rest on the connectors.
- Solder all the pins.
- Your done assembling the board!
Ask about this board
No comments yet. Be the first to ask about this board.