Imported from GitHub: primevivian/eobard · commit 21b54d4 · license GPL-3.0

Description

A split ortholinear 34 key keyboard based on the Raspberry Pi Pico.

README

Meet Eobard, a split 34 key ortholinear keyboard.

Current Hardware Revision: 1.0

Project Description

Eobard is an ortholinear 34 key split keyboard made for my personal needs. Inspired by the Ferris.

The columns are spaced out vertically so as to provide the most comfortable typing experience for my hand size. It is designed to be cheap to manufacture and simple to assemble. The single PCB is dual sided, only having to be flipped around for assembly of the other side.

Project Updates

I've lost interest in split minimalist keyboards like this after thoroughly using my first prototype since then. These are too limiting for my use case. I still want to finish this project and polish all that needs to be polished. The board design is done (has been for a while), removing the diodes from the previous version, as the Pico board had enough pins to directly wire each switch, and the OLED screen which was kinda useless when the point is to not look at your keyboard. As it stands, it just needs firmware to be done but I will not be making any contributions to this any time soon.

• Design Layout.
• Design PCB & Plate.
• Generate Gerbers.
• Build Prototype.
• Write Firmware.
• Write Build Guide with images.
• Release First Version.

Images (First Prototype)

Bill of Materials

• Raspberry Pi Pico [x2]
• PJ-320A 3.5mm Audio Jack [x2]
• Cherry MX Style Switches [x34]
• 4mm M2 Standoff [x9]
• 3mm M2 Screws [x18]
• 01x20 2.54mm Standard Male Pin Headers [x4] [If Pico doesn't have them pre-soldered]

Ordering PCBs

Dragging and dropping the provided Gerber zips onto JLCPCB or other manufacturer's websites should work just fine. Make sure the plate PCB is 1mm thick and the main pcb is 1.6mm thick.