Imported from GitHub: Beaupre-Circuit-Design/c64-xum1541 · commit e5956ff · license MIT
Description
An OpenCBM compatible interface for the 1541 disk drive that can be used to backup and restore floppies.
README
XUM1541 Parallel Adapter
Introduction
A SpeedDos compatible interface for the 1541 disk drive to enable parallel communication.
Components and assembly
Component selection isn't terribly critical, whathever you have in hand that fit the values will probably work just fine. Values for the led resistors will drive them at around 18ma which may be quite bright, increase the values if it's the case.
As alway, when assembling, start with the smallest components and grow in size as you go.
| Qty | Ref | Value | Description |
|---|---|---|---|
| 1 | D1 | Red Led | Light Emitting Diodes Red Diffused 5mm 20mA/1.9V |
| 1 | R1 | 180Ω | Resistors 180Ω Axial Leaded Through Hole |
| 1 | SW1 | SW_Push | Micro-Switch 6x6mm |
| 1 | UP1 | C64 User Port | 24 Pins 805 Series 3.96mm Pitch PCB Slot Solder Card Edge Connector |
Licence
This work is licensed under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-sa/4.0/ or send a letter to Creative Commons, PO Box 1866, Mountain View, CA 94042, USA.
Revision History
| Revision | Description |
|---|---|
| 1.0 | Initial prototype |
No comments yet. Be the first to ask about this board.