Browse hardware designs
BoardRepo is the GitHub for hardware. View any KiCad schematic, PCB, and BOM in your browser and download the sources, no install and no account needed.
Public designs
An IOT device built of the raspberry pi
The source for the environmental sensors used at Kwartzlab
PART (Purdue Aerial Robotics Team) PDU (power distribution unit) and Pixhawk Carrier KiCad projects and accompanying embedded code
ESP32 Firmware for controlling a train
Want to send measurements back to a server through HTTP or MQTT? This is about it along with the PCB design, 3D box and support for data storage with maticas API
using ESP32C3 chip to collect and analyze air quality data
ESPHome Indoor Multi-Sensor hardware. This design supports Radar/PIR Presence, Temperature, Humidity, Pressure, Light, CO2, CO, VOC, NOX and PM sensors. Add a speaker and microphone and you have the kitchen sink too! Click the link below to configure a new device.
LibreCellular RF Front-End Hardware Design
IOT BandSelector (also known as a Band Decoder) works with Antenna Switch Controller to perform automated antenna selection on band change
Custom keyboard using the caps from the Alcatel-Lucent MMK, built with Onshape and KiCad
Olin's National Eclipse Ballooning Project team repository
Hardware for OreSat's SDR GPS receive and other SDR GPS projects
Mechanical keyboard for left hand with Raspberry Pi Pico for games.
ESP32-based BLDC motor controller built with ESP-IDF, utilizing Hall sensors and the hardware MCPWM peripheral.
Saul Sanchez Abreu 20211867
Code and PCB designs for AutoBloomer MQTT sensor modules
NNA-FPGA-Power-Measurement-System
A prototype Full Stack fully Open Source NV Center Diamond Magnetometer