Loading 3D model… large boards can take a moment.
Motorized automatic solder paste dispenser. Easily printable on a 3D printer at home
larger syringe 10 ccm
redesigned mechanism of operation and piston mounting and mainly redesigned Syringe mount, which can be removed and put on without disassembling the dispenser
!! warning component links may be invalid over time !!
Source code of Firmware is optimized for STM32CubeIDE and CubeMX software from ST Microelectronics.
Source code are easy aplicable to another IDE.
It would be a little more difficult to migrate to the Arduino IDE, but even that is partially possible - it has not been tested
CAD files are designed in SolidWorks, preview here:
Auto Extrusion cycle:
Manual Extrusion
Manual Retract
PULL button switch ON -> retraction until the PULL button is switch OFF. This mode is using for remove and fill Syringe.
After selection, all parameters are immediately saved in the emulated EPROM (FLASH CPU).
Speed: 5, 10, 15 ...... 100% step by 5%
Retract duration: 0(dissable), 100, 200 ...... 2500ms step by 100 milliseconds
Pulse after piston returned from retraction: 0(dissable), 100, 200 ..... 1500ms step by 100 milliseconds
Continuous measurement of battery voltage and CPU temperature
The firmware uses a non-blocking I2C DMA routine for the OLED display (this saves about 20 ms in the loop) and Loop() no waiting to DMA complete as is usual in many of the examples given, which then makes the DMA a blocking wait routine
In addition, non-blocking User Timers derived from SysTick interrupts are used, which do not stop the CPU while waiting for the Timer to run out. The number of these Timers is limited only by the CPU speed and the amount of allocated RAM) more about this in loop.c
Tasks
The continuation of the work consists in the completion of the control button mounted on the Syringe tube and the tuning of the SW for optimal paste dispensing. This is a game with engine on and off times and duty cycle of PWM wave
Create a video with instructions for assembly and demonstration at work. Soon.
electronics attachment and power supply solution for the future possibility of 12V power supply from a 3D printer.
Next step is using this solder paste dispenser with a 3D printer. It may be necessary to use a stepping motor for dispensing instead. It has a better and more accurate dispensing control option. I have already finished the PCB for this variant with the DRV8825 controller and the NEMA14 stepper motor.
UPDATE 11/22/2021:
No comments yet. Be the first to ask about this board.