Loading 3D model… large boards can take a moment.
Simplifies circuit prototypying with the ATtiny xx14.
Features:
Videos:
Improvements:
Fixes:
Use this "blink" code to check proper soldering for all ATtiny pins:
// BLINK ALL ATtiny xx14
void setup() {
pinMode( PIN_PA4, OUTPUT );
pinMode( PIN_PA5, OUTPUT );
pinMode( PIN_PA6, OUTPUT );
pinMode( PIN_PA7, OUTPUT );
pinMode( PIN_PB3, OUTPUT );
pinMode( PIN_PB2, OUTPUT );
pinMode( PIN_PB1, OUTPUT );
pinMode( PIN_PB0, OUTPUT );
pinMode( PIN_PA0, OUTPUT );
pinMode( PIN_PA1, OUTPUT );
pinMode( PIN_PA2, OUTPUT );
pinMode( PIN_PA3, OUTPUT );
Serial.begin( 9600 );
}
void loop() {
digitalWrite( PIN_PA4, HIGH );
digitalWrite( PIN_PA5, HIGH );
digitalWrite( PIN_PA6, HIGH );
digitalWrite( PIN_PA7, HIGH );
digitalWrite( PIN_PB3, HIGH );
digitalWrite( PIN_PB2, HIGH );
digitalWrite( PIN_PB1, HIGH );
digitalWrite( PIN_PB0, HIGH );
digitalWrite( PIN_PA0, HIGH );
digitalWrite( PIN_PA1, HIGH );
digitalWrite( PIN_PA2, HIGH );
digitalWrite( PIN_PA3, HIGH );
Serial.println( "on" );
delay( 500 );
digitalWrite( PIN_PA4, LOW );
digitalWrite( PIN_PA5, LOW );
digitalWrite( PIN_PA6, LOW );
digitalWrite( PIN_PA7, LOW );
digitalWrite( PIN_PB3, LOW );
digitalWrite( PIN_PB2, LOW );
digitalWrite( PIN_PB1, LOW );
digitalWrite( PIN_PB0, LOW );
digitalWrite( PIN_PA0, LOW );
digitalWrite( PIN_PA1, LOW );
digitalWrite( PIN_PA2, LOW );
digitalWrite( PIN_PA3, LOW );
Serial.println( "off" );
delay( 500 );
}
No comments yet. Be the first to ask about this board.