Loading 3D model… large boards can take a moment.
DExx-vd_isl is advanced video digitizer add-on module for a number of Terasic FPGA development boards. It has been initially used as a development board for OSSC Pro scan converter but over time has been tailored towards a standalone product. Please check the wikipage for more information on usage and latest features.
PCB and firmware of the project are open-source except for certain Intel VIP modules which are planned to be replaced by custom implementations over time. For most parts RTL and SW are derived from OSSC Pro project with only small amount of adaptation code for the supported development boards.
Hardware
Software
NOTE: If the software image (software/sys_controller/mem_init/sys_onchip_memory2_0.hex) was not up to date at the time of compilation, bitstream can be quickly rebuilt with updated hex by running "Processing->Update Memory Initialization File" and "Processing->Start->Start Assembler" in Quartus.
NOTE2: Without Intel VIP license it's only possible to generate a time limited bitstream which needs connection to USB Blaster during use. VIP modules can be excluded by commenting out the "VIP" define from both top-level RTL and sysconfig.h in which case scaler mode is disabled.
cd board/<board>/software/sys_controller_bsp
nios2-bsp-generate-files --settings=settings.bsp --bsp-dir=.
cd board/<board>/software/sys_controller
make [OPTIONS] [TARGET]
OPTIONS may include following definitions:
TARGET is typically one of the following:
nios2-download sys_controller.elf --go
Depending on target platform, bitstream can be either stored into serial flash chip or SD card where it is automatically loaded every time FPGA is subsequently powered on.
To program flash on compatible boards, FPGA configuration file must be first converted into JTAG indirect Configuration file (.jic). Open conversion tool ("File->Convert Programming Files") in Quartus, click "Open Conversion Setup Data", select "ossc.cof" and press Generate. Then open Programmer, add generated file (output_files/.jic) and press Start after which flash is programmed. Installed/updated firmware is activated after power-cycling the board.
See board specific notes for building a SD card image containing the bitstream.
make clean && make APP_CFLAGS_DEBUG_LEVEL="-DDEBUG" mem_init_generate
nios2-download sys_controller.elf --go && nios2-terminal
Remember to close nios2-terminal after debug session, otherwise any JTAG transactions will hang/fail.
No comments yet. Be the first to ask about this board.