Imported from GitHub: nurk/kitchen_timer · commit 8ee9058 · license AGPL-3.0

Description

Kitchen timer

README

Disclaimer

I am not a microcontroller developer nor am I a C-plusplus developer. I am also definitively not a hardware designer.

Kitchen timer

A long time ago my lovely sister gave me a kitchen timer which would beep once when there are 10 minutes left and twice when there are 5 minutes left. Unfortunately time got the better of the timer and it broke but I got hooked on those features.

I have been unable to find a replacement but after dabbling with some circuits a bit I thought I might be able to make my own.

This repository contains the version(s) that I deem worthy of the internet.

You will find a software and hardware folder with each containing the respective versions.

The hardware folder contains a KiCad project where the symbols and footprints used have been added to a local library. You will also find a pdf of the schematic, a screenshot of the pcb and a screenshot of the 3D rendering.

The software folder contains an arduino ide project with the, well, software.

User guide

I am not going to explain how to use a kitchen timer. If the main function of the 4 buttons does not speak for themselves I did really bad. I am only going to explain the extra features.

Timer / C°

This switch toggles the display to show the timer and the measured temperature.

Loud / Quiet

I bought cheap buzzers on amazon and they all seem a bit different. Some are quiet and some are loud. Because I was tired of changing the inline resistor for the buzzer I added a toggle to switch between two values. One is louder, the other is quieter.

Reset long press

Because you can fully turn off this device a way was needed to set the time for when you turn on the device. The chance of you needing a timer of 0 minutes and 0 seconds is very slim.

After setting a time you can long press the Reset button until you hear a second beep and the set time will be stored. When cycling the power the stored time will be loaded.

Start/Stop long press

When you long press the Start/Stop button the letter A will appear and you will have entered the setup menu. After releasing the Start/Stop button you will see A5. 0. Clicking the Start/Stop button will cycle through the menu items:

Displayed	Meaning
A5. 0	5 minute alarm
A10.0	10 minute alarm
A15.0	15 minute alarm
A20.0	20 minute alarm
C 0.0	Temperature offset*

* This was added in version 6.4. It is a C because I cannot make a T with a 7-segment display.

For the alarms, the value after the . is the number of beeps that will sound when there are 'x' minutes left. You can use the Minutes button to increase the number of beeps and the Seconds button to decrease the number of beeps.

To exit the setup menu just click the Reset button.

Miscellaneous

Some component sizes might seem big for some. Especially resistors and capacitors of size 0805. Keep in mind I am hand soldering this and I am becoming an old fart with bad eyesight.

The microcontroller is an ATmega4808 which has way more flash storage than is needed. I still chose this one because it is what I have and I am not going to buy a new variant for each project I do.

The battery charge controller I chose only charges at 500mA. So you will need a battery with at least this capacity (or you have to change the resistor on the programming pin). I have a 2000mA battery connected and I takes a fair while to charge.

This is not a cost effective way to get a kitchen timer. If you need one you are better of going to the store and buying one.