BrowseBoardRepo

diy-pl18-internalmpm

Public

@richardclli

Download board files

Files for version 1. Pick what you came for.

KiCad projectAll 12 files, ready to open in KiCad408 KBSchematic PDFEvery sheet, to read or print105 KB3D modelThe board with its parts, for an enclosure (GLB)3.6 MB
Browse all files

Share diy-pl18-internalmpm

Check access before sharing the link.

Who can open this board

Anyone can open this board. No sign-in is required.

https://boardrepo.com/richardclli/diy-pl18-internalmpm

This link opens the latest version. Copying it does not grant additional access.

Loading 3D model… large boards can take a moment.

README

DIY-PL18-InternalMPM

An internal MPM (Multi-Protocol Module) for Flysky PL18 Mod

This internal module works with the modified version of Flysky PL18 that flashes with EdgeTX:

https://github.com/EdgeTX/edgetx/wiki/PL18-Hardware-Mod-for-Complete-EdgeTX-Support

For MPM firmware download, please visit the official page:

https://github.com/pascallanger/DIY-Multiprotocol-TX-Module

Installation Procedures:

  1. Add an antenna to the PL18

  1. Solder the power control wire to PI.00 pin

  1. Install the PCB and insert the power control pin, you may need to use a sticky tape to ensure the MPM PCB is fixed to the PL18 PCB properly.

Note: The 100k pull up resistor for the power control pin is for testing purpose, it DO NOT NEED to be soldered as per the images shown.

Comments

No comments yet. Be the first to ask about this board.

Ask about this board

Sign in to BoardRepo

New here? Signing in creates your account; there is no separate sign-up.