Programming the firmware

• Clone or download this repository.
• Edit config.h file and set the correct PCB version by uncommenting the correct line:

• You will need a USBASB compatible programmer and either the programmin adapter above (recomended) or connect your own wires.
• NOTE!!! USBASP must be 3.3V version or you risk damaging the receiver.
• The software is arduino compatible (Arduino nano), so it should work with the Arduino IDE, however I did not test that. Instead I recommend using the VS Studio Code IDE. You will need to install the C/C++ Addon, and the Platform IO addon (from the addon menu). Within Platform IO install the Atmel AVR platform.
• Connect the built receiver to the programmer using the adapter as follows:
  For FR-8:

For FR-Tiny:

For FR-LVH:

• Now open the 'Software' folder within VS Code. If you get a mesage that a workspace was detected, go ahead and press the "open workspace" button.
• On the left, click the PlatformIO icon (bug head), and from the "Project Tasks" menu, click the "Set fuses" line (should be under nanoatmega328->Platform). If everything is connected correctly, the Microcontroller fuses will be programmed.
• Now just press the 'PlatformIO: Upload" button at the bottom (the right arrow) and thats it!

Usage

These receivers works with FR-Sky telemetry compatible transmitters (D8). (SW 1 and 2 off on DJT modules)

Binding

You first need to bind the receiver with the transmitter (this is a one-time operation, repeat only if you change transmitter):

• Press and hold the bind button and then powerup the receiver. Wait for the green light to turn on.
• Start binding procedure in your transmitter. If you are using an external module such as the DJT, Press and hold the module bind button and turn on the transmitter.
• Wait for the red led on the receiver to start blinking. When it does, binding is complete! Turn off the transmitter and remove the receiver battery.

Setting Fail safe

turn the tranmitter on then the receiver. Wait for the receiver green light to turn on. Press and hold the Bind button on the receiver for about 5 seconds till the red led turn on. Release the button, the red led will start blinking. You now have 10 seconds to set your fail safe state using the transmitter. When the time is up, the receiver will lock this state as the failsafe mode, and restart. when the green light is on again (without the red) the process is complete. This method of setting the fail safe mode is better then the standard, since you have both hands free to move the sticks to the desired state.

Serial debugging

If you want to debug the receiver operation, you can use a serial terminal (built in VS code) to observe the debug data sent from the receiver.

• Use a USB to serial Adapter. If you want to use the USB-serial to power the module, Make sure its a 3.3V version, or you risk damaging the modules.
• Connect the USB-Serial adapter to the programming adapter using the marked pins.
• Connect the programming adapter to the module as explained in the programming section.
• For the FR-Tiny you are all set. For the FR-8 / FR-LVH you will need an extra cable (jst to jst 1.0 mm 3pin) to connect the module to the serial input: