Loading…
An all in one board for driving neopixel, or equivalent, led strips using an Arduino Nano
WARNING: THIS BOARD IS 5V ONLY. APPLYING A HIGHER VOLTAGE WILL RESULT IN A DEAD ARDUINO AND LEDS
Instructions for the jumpers on the back
Adafruit recommends putting a 470 ohm resistor in series with the WS2812B data line. To acomodate both LED and GPIO signals, the back of the board has a resistor footprint and a solder jumper for each exposed DIO. Populate the resistor for DIO that will drive an LED signal, and solder the jumper for DIO that will be GPIO.
Assembly
BOM
1x Arduino Nano
1x 1000uF Würth Elektronik 860010274015 (or comparable capacitor with same footprint)
8x 470 ohm 0805 resistors
Loading 3D model… large boards can take a moment.
No comments yet. Be the first to ask about this board.