SOICbite

A compact PCB footprint which allows SOIC test clips to be used as a space-efficient programming and debugging connector

This is the repository for a hackaday.io project on this connector footprint.

It's cheaper than a Tag Connect and may even be smaller.

This has been tested as a SPI programmer on AVRs and a UART programmer on ESP32.

The footprints are available in the following formats:

• Kicad (.kicad_mod)
• Eagle XML (.lbr)
• gEDA PCB (.fp)
• pcb-rnd (.lht)

and more formats are welcome.

You do need to adjust your SOIC-8 test clip so that it will close enough to press the contact pins against the PCB pads. See the photos in the images folder - about 1mm will do to start with. Depending on your pin configuration, you need to make sure opposing contacts don't touch each other when no PCB is between them.

Also, you may need to use short sections of thin traces to escape the pads between the NPTH.

Pin assignment

If you don't know where to start, here are a few suggestions for pin assignments of some interfaces:

Pin	UART	SPI	SWIM	SWD	ESP8266	USB	I2C	PIC ICSP	JTAG	SWD + UART	UPDI
1	Vcc	Vcc	Vcc	Vcc	Vcc	Vcc	Vcc	Vcc	Vcc	Vcc	Vcc
2	RX2	CS			GPIO0	D-		Vpp	TMS	RX
3	TX2				GPIO2	D+			TCK	TX
4	GND	GND	GND	GND	GND	GND	GND	GND	GND	GND	GND
5	RX	MOSI/MOMI	SWIM	SWDIO	RX		SDA	DAT	TDI	SWDIO	UPDI
6	TX	MISO		SWO	TX			AUX	TDO	SWO
7	CTS	SCK/CLK		SWCLK	CH_PD		SCL	CLK	RTCK	SWCLK
8	RTS	RST	NRST	NRST	RST	ID			NRST	NRST