Loading 3D model… large boards can take a moment.
SD card (2x) to ACSI hard drive interface.
This project aims to develop a reliable and useful hard drive solution for Atari ST with two SD card sockets and a battery-backed clock, satisfying the ACSI protocol, voltage, and timing requirements as given in available specifications.
Features:
You will need to install:
avr128da microcontrollers, cross-compiled for AVR (e.g. 5.4.0).avr128da microcontrollers - https://www.nongnu.org/avr-libc/. You may need to get this from their github repo.avr128da; "
Microchip AVR-Dx Series Device Support (2.4.286)" will pop open. Download this file, then change the file extension to .zip
and unzip it into the directory mcu-source/atpack.mcu-source:Makefile and set up LIBC variable to reflect the path to avr-libc on your systemAVRDUDE variable to reflect your programmer setup (probably just the path)avrdude.confmake flashYou will need to install Quartus Lite which is a free download from Intel, although you will need to create an account.
Make sure you install MAX V family support
You will also need a "USB-Blaster" or compatible programmer.
If using Linux, you will very likely need to install a udev "rules" file for the programmer before it'll work.
Just open the project in Quartus, go to "start compilation", then after it's compiled, open the programmer tool and program the chip. It should auto-detect the settings. If it doesn't find the USB Blaster hardware then it's probably udev's fault.
No comments yet. Be the first to ask about this board.