Loading…
This is the sourcecode and plans for my home automation system.
homecontrol: Sources and schematics for a simple AtMega based home automation controller with 8 24VDC digital inputs, 8 24VDC digital outputs (open collector), RS232 and 2 230VAC sense inputs.pixtend: Sources for the main controller, based on an PiXtend v2-S with Raspberry 3B, written in Python. Connects via RS232 and MQTT to the network.sudo rpi-imager: Enable SSH, set hostname, username, password# Enable SPI, UART, console bootup, set locale
sudo raspi-config
sudo apt install vim screen git gpiod libgpiod-dev python3-dev python3-pip python3-paho-mqtt
git clone https://git.kontron-electronics.de/sw/ked/raspberry-pi/pixtend-v2/pplv2.git
cd pplv2
git checkout 0.1.6-dev
python setup.py bdist_wheel
# Install into venv
python -m venv ~/.venv
source ~/.venv/bin/activate
pip install dist/pixtendlibv2-0.1.6-py3-none-any.whl
# Install prerequisites
. ~/.venv/bin/activate
pip install pyserial paho-mqtt
cd ~/homecontrol/pixtend
sudo cp pixcontrol.service /etc/systemd/system/
sudo systemctl enable pixcontrol
This program is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program. If not, see https://www.gnu.org/licenses/.
Loading 3D model… large boards can take a moment.
No comments yet. Be the first to ask about this board.