Loading…
Ethernet JIG for Nucleo H743ZI2
This is a LAN9220 ehternet controller board for the Nucleo H743ZI.
The LAN9220 is accessible through the FMC SRAM configuration NE1. The LAN9220 doesn't have READY signal. Thus, the wait cycles should be set by program appropriately.
The following signals could be assigned to the interrupt (EXTI).
The followings are the pin configuration of Nucleo board.
Also, short bridge have to be configured as the followings :
The USART3 is connected to STLINK VCOMM through the PD8 and PD9 by default. These pins are re-assigned to FMC. Thus, the LPUART1 have to be connected to the STLINK VCOMM through the PB6 and PB7.
PD6 (FMC_NWAIT) and FMC_NE1 (PC7) are not used in this board.
This project is licensed by the MIT license.
Loading 3D model… large boards can take a moment.
No comments yet. Be the first to ask about this board.