Loading 3D model… large boards can take a moment.
Yet another MIDI CC controller in 200x75mm footprint. 16 potentiometers x 4 banks. USB-C for flashing and MIDI device communication, hardware TRS MIDI type A output. Option for battery power.
MIDI CCs, channels and scaling per knob for all the four banks are programmable in the firmware (not on the fly via SysEx, at least not yet). Sends identical messages via both USB and TRS.
There are many small DIY MIDI controllers more refined than this one, but I wanted something to use with battery-powered portable electronic instruments like the Dirtywave M8 and Teenage Engineering OP-1 Field, and
Then a friend wanted one like this too for similar reasons, so I had to actually design one.
There's not much to it. A custom carrier board with a power switch, a bank button, two LEDs that indicate which bank is active (00, 01, 10, 11), TRS MIDI port and associated circuitry, and 16 pots read via a single multiplexer.
Adafruit Feather RP2040 is used as the brain. Mainly because it conveniently has both a USB-C port and battery power / charging circuit built in.
First you'll need to get a carrier PCB. KiCad project and Gerbers are included for ordering your own. Once you have that, here's a list of parts you'll need to populate the board:
If you can (hand) solder SOIC and 0603, populating the board is going to be fast and straightforward. Just mind the build order - SMT components first, and if you don't use removable headers for the Feather you might want to solder the pots before that so the Feather won't get in the way. Oh, and mind the SPST power switch polarity if you actually want "power off" to be on the left and "power on" on the right...
The repository includes a simple "sandwich" type panel design. If you use that, you'll also need some M3 spacers and screws. The exact height will depend on eg. how you mount the Feather. Try eg. 6x 10-12mm male-female ones for the front side (just attaching the panel using pots and power switch is OK too), 6x 17-18mm female-female ones for the back, plus 12x short screws to put it together.
If you use removable header stack for the Feather, you may also want to secure the board in place with a short M2.5 spacer / screw and nut. Otherwise it may slip off during weeks / months / years of use.
For keeping the battery in place, use something like 3M Dual Lock or generic velcro to attach it to the bottom of the PCB or bottom panel. That way you can actually remove and replace the battery if you need to, but it won't move around.
Firmware can be edited and flashed with Arduino IDE. You'll also need to install these libraries (see instructions in respective repositories):
After you have the IDE and the libraries installed, open the included Arduino sketch. In Tools menu, select "Adafruit Feather RP2040" as the board and "Adafruit TinyUSB" as the USB stack. Other options can be left as is. Then attach the USB-C cable to the Feather and turn power on. You should now be able to upload the sketch to the Feather via USB.
If the device isn't automatically recognized and you get an upload error, you may have to keep the "bootsel" button (in the back end of the board) pressed, quickly press "reset" towards the front of the board and finally release "bootsel" to get the board to bootloader mode. Then try uploading again.
The sketch also includes the hardcoded MIDI CC mappings for all the four banks. For now, whenever you want to edit the mappings, edit the source file according to instructions in the comments, then upload a new version to the Feather.
No comments yet. Be the first to ask about this board.