Loading 3D model… large boards can take a moment.
An ESPHome-driven smart controller for 12V PWM fans.
Classical radiators (K2/K3) typically require relatively high flow temperatures to heat up a room. Using forced convection can significally enhance their efficiency, especially at low flow temperatures. While there are a number of commercial solutions available, these did not need my needs. They are either too loud while running or switching on/off using a relays, don't properly switch at low flow temperatures, are too expensive or simply not powerful enough. Hence, I set out to build my own solution using standard 120/140mm PWM-capable PC fans. High-end fans run at low speeds (<500 RPM) are essentially inaudible and provide a definite boost to the room temperature. Being able to smartly control the fan speed and integrate them into Home Assistant - while not a must - is definitely very nice to have if you want to control fan speed based on time of day, current room temperature or room occupancy. The fans can even be used as a kind of thermostat to modulate room temperature without restricting flow to the radiators, which is especially crucial when using a heat pump that perform best with an open loop circulation and no TRVs.
Using these devices throughout our house, we can run out heat pump at flow temperatures typically reserved for good underfloor heating setups (Vaillant heat curve at 0.25 - 30°C flow temperature at 0°C, 35°C flow temperature at -10°C).
Don't connect to USB when the Atom lite is plugged into the PCB - there is no mechanism to block voltages between the included buck converter and the computer.
You can set 5 temperature points and associated fan speeds to build a temperature-dependent fan speed response. The speed between the points is interpolated linearly. The temperatures have to increase from 1 to 5; this is also enforced by internal logic. Temperatures above/below the highest/lowest setpoint keep the speed of this setpoint. Set "Auto Fan Curve Control" to on in order to use this feature.
In the below example, the fans are off below 20°C, increase between 0 and 29% speed in the range between 20 and 21°C, then increase up to 100% at 25°C. Above that, speed decreases to 28% at 30°C and the fans are off again at 35°C.
When fan speed is set to zero, the internal high-level switch also cuts all power to the fans. Some fans (e.g. Arctic PXX PWM) turn off with a zero PWM signal and wouldn't need this functionality, however many other fans cannot be turned off via PWM alone.
No comments yet. Be the first to ask about this board.