P42 Pico M.2

A RPi Pico RP2350A microcontroller board in m.2 3024 form factor with A and E key. The m.2 interface has USB, UART, I2C and control IO connectivity. Voltage levels for the m.2 specification are obeyed as some of the interfaces run on 1.8 V. Externally, +3.3 V, GND, the SWD interface and 16 IOs are accessible on castellated pins. A footprint for a QWIIC connector is on the top side of the board, not populated to have the board as low profile as possible. Power rail LEDs and a user controlled LED is on board, as well as a solder bridge for configuration options. Bottom side has a micro-SD card slot for data storage. A microcontroller could give any host computer flexible and excellent real-time IO and data processing capabilities. The RPi Pico with its programmable PIO interface has excellent timing resolution.

Pre-order campaign on Lectronz https://lectronz.com/campaigns/pre-order-p42-pico2-m-2

Full Feature List:

• M.2 2230-D5-AE card (22 mm x 30 mm; D5 = 1.5mm on top and bottom side violated by the QWIIC connector and the bottom SD card holder; A and E key)
• Used interfaces on the M.2: USB, UART, I2C, ALERT, WAKE, DISABLE1/2, LED 1/2, VENDOR_DEFINED
• 1.8V regulator for level-shifters
• Power LEDs for 3.3 V and 1.1 V
• RP2040/RP2350 peripherals: 2 MB Flash, SWD debug access, RESET and BOOTSEL button,
• QWIIC connector, 1 LED, 1 solder bridge for configuration, 16 GPIOs on castellated pins
• castellated pins on 25.4 mm/0.1" raster (almost with a 22 mm board)
• optional uSD card holder on the bottom side
• optional pull-down resistors on castellated IOs to mitigate the E9 Erratum

Main Components

• Microcontroller RaspberryPi RP2350A
• 16Mbit QSPI Flash W25Q16
• 12 MHz Crystal SMD_3225-4Pin_3.2x2.5mm
• MicroSD card holder Molex 104031-0811
• 1.8V-3.3V High Speed level shifter Texas Instruments TXS0102DQM