Loading files…
Newer version (v3) available here.
Detailed information / blog here.
A simple preamp to be used for e.g. guitar piezo (contact) microphones.
Created in KiCAD v7 and LTSpice.
Basically an integrator circuit. Provides low-impedance input. The gain is adjustable and depends on the input piezo capacitance. In my measurements, piezo discs have following capacitances:
But I've also seen mentions of piezo discs with <10nF capacitance. Connecting multiple piezo discs in parallel increases the capacitance, so the maximum piezo capacitance can be in order of ~100nF or so.
The gain of the charge amp is then set by the ration of piezo capacitance to charge amp feedback capacitance. The gain slide switch is used to select from these feedback capacitances:
Input is protected by ESD bidirectional diode.
OPA145 is the opamp of choice because of these characteristics:
Opamp also unfortunately seems to have bias current cancellation, which might introduce more current noise - this has to be determined by measurement. The same opamp is also used for Baxandall tone control section. Two single OPA145 components are used instead of dual OPA2145 package because it's easier to route, minimizes crosstalk and improves power dissipation (less heat). This increases the price, of course.
The charge amp is followed by a simple first-order high-pass filter with switchable cutoff frequency:
The cutoff frequency is selectable by LPF slide switch.
Bass and treble can be adjusted independently by Bass pot and Treble pot in the ranges of +-10dB. The center frequency is switchable by Center slide switch:
Output audio is routed through Volume pot and protected by ESD bidirectional diode.
The power-on LED can work in two modes, switchable by on-board jumper header
Battery indication mode (BI) causes the LED to flash briefly when the circuit is switched on (by inserting mono plug to output jack). The longer the flash, the lower the battery voltage (remaining capacity). Under certain threshold, the LED will stay on permanentnly, signalling the need for replacement. This BI threshold is adjustable by on-board trimmer pot and needs to be determined by voltmeter measurement.
The power-on LED intensity is adjustable by an on-board trimmer pot as well.
Designed for 9V batteries or DC pedal power supplies, but should theoretically be able to work properly with up to 18V DC.
Power enters the PCB by means of Molex PicoBlade connector on board.
Contains ESD protection (bidirectional diode), MOSFET reverse polarity protection (with Zener gate protection and CLR) and input pi filter.
LTSpice simulations (transient, AC, noise, stability) and some graphs are available in ltspice/ folder.
Folder containing all 3rd symbols, footprints and 3D models used in the project. Other than that, only standard KiCAD symbols are used (opamps, ).
Contains some additional resources, inspiration and schematics used during development.
Contains schematic sheets plotted from KiCAD, individually as .png and in one file as .pdf.
No comments yet. Be the first to ask about this board.