Loading files…
The Boardoza BMI088 6-Axis IMU Breakout Board is a high-performance motion sensing solution built around the Bosch Sensortec BMI088 inertial measurement unit. It combines a 16-bit three-axis accelerometer, a 16-bit three-axis gyroscope, and an 11-bit internal temperature sensor to provide accurate motion and orientation data even in environments with intense vibration. An onboard 3.3V voltage regulator and bidirectional logic-level shifter enable seamless interfacing with both 3.3V and 5V microcontrollers.
Designed for reliable operation in demanding applications, this breakout board supports both SPI (default) and I²C communication interfaces, making it suitable for drone flight controllers, autonomous robots, camera stabilization systems, industrial automation, motion analysis, and other embedded sensing projects requiring precise inertial measurements.
| Front Side | Back Side |
|---|---|
BMI088 Boardoza Bosch Sensortec 3.3V – 5.5V DC 3-axis Accelerometer, 3-axis Gyroscope, Internal Temperature Sensor 16-bit 16-bit 11-bit Up to ±24g Up to ±2000°/s SPI (default) / I²C (JP1 selectable) 0x19 (default) / 0x18 (JP2 shorted) 0x69 (default) / 0x68 (JP2 shorted) -104°C to +150°C -40°C to +85°C 40mm × 20mm
| Pin Number | Pin Name | Description |
|---|---|---|
| 1 | SCK / SCL | SPI Clock / I²C Clock |
| 2 | MOSI / SDA | SPI MOSI / I²C Data |
| 3 | nCS2 | Gyroscope Chip Select (Active Low) |
| 4 | nCS1 | Accelerometer Chip Select (Active Low) |
| 5 | MISO | SPI Data Output |
| 6 | GND | Ground |
| Pin Number | Pin Name | Description |
|---|---|---|
| 1 | VCC | Power Supply Input (3.3V–5.5V) |
| 2 | GND | Ground |
| Pin Number | Pin Name | Description |
|---|---|---|
| 1 | INT1 | Accelerometer Interrupt Output |
| 2 | INT3 | Gyroscope Interrupt Output |
Note: JP1 is used to select the communication interface. Leave JP1 open for SPI operation or short JP1 to use the I²C interface. JP2 is used to change the I²C addresses: when open, the accelerometer address is
0x19and the gyroscope address is0x69; when shorted, the addresses become0x18and0x68.
This repository contains both hardware and software components:
All hardware design files are licensed under Creative Commons Attribution-ShareAlike 4.0 International License.
All software and firmware are licensed under BSD 3-Clause License.
No comments yet. Be the first to ask about this board.