Loading files…
Warning: this Upgrade is a Major effort and is recomended for Advanced 3D Printer Users with some electronics skills only. If you would like to keep your OEM mainboard and wiring, please see the Klippventure project by VioSynthax.
are available via Printables:
https://www.printables.com/model/437968-flashforge-adventurer-3-klipper-revo-6-bltouch-btt
FlashForge Adventurer 3 gets a new Brain, Hot-End and Klipper: https://youtu.be/USZoIhBnA24
Sensorless Homing in Action: https://youtu.be/0Acrmv7VkdY
and Printing ASA: https://youtu.be/akCvX6l-e6o
The factory belt tension on this printer is too loose to exceed 1k acceleration and 100mm/s print speeds. To rectify this you need to retension the X and Y axis belts properly (tight is good, but dont over do it). The Y axis is a PITA as it can only be fixed when the printer is fully disassembled. The Y belt is a continuous loop with no tension adjuster. So you'll need to cut out roughly 5mm from the belt and re-install it as snug as you can get it. I then used some "Selly's Power Grip" to ensure the belts dont jump out of the jaws holding them.
If you still have Y axis layer shifting, I recommend replacing the motor with a better quality unit.
No comments yet. Be the first to ask about this board.