Fault latch for IMD and BMS/AMS

This board is a fork of JacobParent7/FSAE_ELECTRONICS. Thanks!

Overview

It is stripped down for our purposes of using it just as a fault latch if either IMD or BMS signal an error. So it can open and close the SDC (Shutdown circuit).

As input it needs +12V and GND. It also takes a high input of both IMD and BMS to register a fault.

It has two outputs for LEDs, these go into the cockpit of the car, to signal issues to the driver.

Lastly there is one connection where the SDC is routed through.

Used parts

[!WARNING]
Part list is not available currently.

Article	Description	Link	Quantity