Loading…
Hardware design for the flatmcu - an STM32G4 based BLDC / FOC motor controller.
All schematic and layout was created with KiCad EDA (https://kicad.org).
The controller is based on the STM32G473CB microcontroller from ST Microelectronics. It contains an ARM Cortex-M4 core at up to 170MHz. The three-phase bridge driver is the TI DRV8353RS, which also contains shunt resistor current sensors and a 95V buck regulator.
The MOSFETs in the three-phase bridge (Toshiba TPW4R50ANH) are dual-side cooling. There's a large metal pad on top of them. A heatsink should be attached there. The opposite side of the board is intended for soldering on the large battery and phase wires.
Loading files…
No comments yet. Be the first to ask about this board.