Loading files…
Feedback is very welcome!
CC BY-SA 4.0Overviews:
Design documents:
Debuggers:
Software:
Discussions:
Moving to STM32H7:
I have been using JLCPCB.
6f9e281abe9c22ef3b995376c3df42217fc04524I received two fully populated boards. One was missing the J5 header.
e48a22093a1c81bb14c9082240e3d44837e7d75eResults:
TODO:
Using EasyEDA2KiCAD:
EASYEDA2KICADeasyeda2kicad Nickname${EASYEDA2KICAD}/easyeda2kicad.prettyeasyeda2kicad Nickname${EASYEDA2KICAD}/easyeda2kicad.kicad_sym Library Path4-layer design with Signal/GND/GND/Signal for EVT board.
Will do most important routing first on the top copper layer:
Remaining signals will be routed using "Manhattan routing." That is, one signal layer will run up/down, the other will run left/right, mostly.
After that, do these routings:
Fill in some positive power areas with fill.
Finally, the signal layers will be filled with GND at the end, and the ground planes should be stitched together with lots of vias.
Docs say you need a 4.7 uF ceramic capacitor with low ESR DS11853 Rev 9 page 105
ISOM8710 is a drop-in replacement for the TLP2362
Longer term
python -m easyeda2kicad --full --lcsc_id=Cxxxxx
No comments yet. Be the first to ask about this board.