Build a portable / mobile PCB etching workstation that fulfills these criteria
waterproof
able to etch 100x160mm double sided boards with 8mil precision
low cost. total bill of materials should not exceed 150 CHF
diy approach, mostly laser cut plexi and easily sourceable materials
fits in a RAKO Box
Some guiding ideas
use very little but always fresh chemicals
good heat management: etching has to be done at 45-50 degrees celsius, developer has to be kept at >20 degrees as well (in my workshop, temperatures can easily drop below 16 degrees and developing is a pain).
all material and chemicals travel in the box. liquid waste can travel in the box as well until it can properly disposed of.
should be easy to clean. no electronics exposed to moisture.
as few as possible switches and electrical contacts exposed to the harsh etching environment
No comments yet. Be the first to ask about this board.