A hobby hardware and logic design project that decodes Morse code input into discrete Dit (Dot) and Dah (Dash) shift register arrays using pure analog timing circuits and discrete digital logic, without requiring any microcontrollers.
🚀 Overview
This project implements a temporal-logic state machine to parse Morse code inputs. By measuring the duration of a button press using an RC charging network and Schmitt-trigger buffers, the circuit discriminates between short pulses (Dits) and long pulses (Dahs), shifting them into separate 8-bit serial-in, parallel-out shift registers to display the incoming character pattern visually via an LED array.
🛠️ Circuit Architecture & Components
1. Integrated Circuits (ICs)
U1 (74HC14): Hex Schmitt-Trigger Inverter (used for signal shaping, debouncing, RC timing discrimination, and clock-edge generation).
U2 (74HC164): 8-Bit Parallel-Out Serial Shift Register (Dash / Dah sequence array).
U3 (74HC164): 8-Bit Parallel-Out Serial Shift Register (Dot / Dit sequence array).
2. Passive Components & Semiconductors
Resistors:
R1, R3 (10kΩ): Pull-up resistors for reset and input logic states.
R2, R4 (1kΩ / 100kΩ): Analog timing and isolation components for the RC charge/discharge network.
D1 (1N4148): Switching diode controlling charge/discharge pathways in the timing circuit.
Displays & Controls:
SW1: Momentary push button (Master Reset).
SW2: Momentary push button (Morse Key Input).
LED Arrays (LED_Dual_AAK): Dual-color indicators displaying the shifted dot/dash sequences.
J1: 2-pin screw terminal / header for 5V DC Power Input.
⚡ Power Requirements
Operating Voltage:5V DC regulated supply.
All logic ICs belong to the 74HC High-Speed CMOS family (operating safely between 2V and 6V).
Decoupling capacitors ($100nF / 0.1\mu F$) are recommended across the VCC and GND pins of each IC on the PCB layout to suppress transient voltage spikes.
@rrenamed · Oct 5, 2026
why are there floating CMOS inputs on U1? pins 11 and 13 I mean
ChatGPT told me: Floating CMOS inputs can sit mid-rail, causing extra quiescent current draw and potential oscillation/noise coupling into the rest of the chip. Best practice is to tie unused inputs to GND or VCC even if the gate's output is unused.
why are there floating CMOS inputs on U1? pins 11 and 13 I mean ChatGPT told me: Floating CMOS inputs can sit mid-rail, causing extra quiescent current draw and potential oscillation/noise coupling into the rest of the chip. Best practice is to tie unused inputs to GND or VCC even if the gate's output is unused.