Loading files…
A visual light communication system developed and designed to be used as ambient light. It uses two Arduinos to modulate and demodulate light transmissions at a high frequency so the user does not experience light flickering. This system can be used in any building requiring Wi-Fi coverage where structural layouts create areas with poor signal.
To use the system, upload the file transmitter\tx_code\tx_code.ino to one Arduino and the file receiver\rx_code\rx_code.ino to another. Then, follow one of two options to build the transmitter and receiver modules:
To use a PCB model, utilize the fabrication files located under transmitter\transmitter_board\fab_files and receiver\receiver_board\fab_files to build both boards:
Transmitter Board:
The pins on the PCB are, from top to bottom: Power, Ground, and Signal. The signal pin connects to Arduino digital pin 13.
Receiver Board:
The receiver module requires a solar panel on the empty slot at the top. The pins on the PCB are, from left to right: Ground, Power (1V), Power (5V), and Signal. The signal pin connects to Arduino digital pin 2.
By following the schematics, you can build the circuit on a protoboard or similar (this is how we tested our system).
[!WARNING] Ensure that both 10Ω resistors in the transmitter module (left) are rated to withstand the required power without overheating.
Once everything is connected, start both Arduinos. Any message written through the serial port of the transmitter Arduino will be displayed through the serial port of the receiver Arduino.
[!NOTE] The modulation algorithm is designed to work with individual uppercase and lowercase alphabetical characters, so words are transmitted character by character.
[!CAUTION] If no data is received, or the data received is not the same as the one sent, ensure the solar panel receives sufficient light from the LED and that ambient light, such as solar, is not interfering.
MIT License 2025 - Toni Calvo Belmonte. Take a look at the LICENSE.md for more information.
No comments yet. Be the first to ask about this board.