Loading files…
Embedded Hardware–Firmware Co-Design Project
The Motor Health Monitoring System is an embedded systems project designed to monitor the operational health of an electric motor and protect it from unsafe conditions.
The project integrates:
The focus is on learning, reliability, and design clarity, following workflows commonly used in industry and academia.
System initialization
Peripheral setup
Sensor sampling
Data filtering
Threshold comparison
Fault decision
Motor control update
Display & UART update
Continuous monitoring loop
Power Input
│
V
Voltage Regulation
│
V
Microcontroller (8051)
|--> Sensor Interface
| |--> Current
| |--> Temperature
| |--> Vibration
| |--> IR Sensor
|
|--> Motor Driver (PWM Control)
|--> Display (OLED)
|--> Keypad Interface
|--> UART Debug Interface
| Aspect | Description |
|---|---|
| Controller | AT89C51 (8051 architecture) |
| Control Method | Bare-metal |
| Sensors | Current, Temperature, Vibration, IR |
| Motor Control | PWM-based with fault shutdown |
| Display | OLED (I²C) |
| User Input | 4×4 Keypad |
| Communication | UART |
| Validation | Proteus Simulation |
| PCB Status | Not fabricated |
The repository contains:
Complete hardware schematics
PCB layout and 3D models (design stage)
Proteus simulation files
Modular firmware source code
Structured documentation
| Parameter | Value |
|---|---|
| Supply Voltage | 5 V DC |
| MCU Logic Level | 5 V |
| Over-Current Threshold | 15 A |
| Over-Temperature Threshold | 70 °C |
| Communication Baud Rate | Configurable (UART) |
| Fault Response Time | Deterministic (loop-based) |
The system was simulated using Proteus 8.1 Professional software to validate firmware behavior and system-level logic prior to hardware availability. The AT89C51 microcontroller, UART interface, motor control logic, fault indicators, and peripheral connections were instantiated according to the schematic.
Sensor inputs were emulated using adjustable sources to exercise overcurrent and overtemperature fault paths. UART output was used to confirm firmware execution flow and system state transitions. Motor operation was verified logically through enable signals and status indicators rather than physical motor dynamics.
Due to simulator limitations with mixed-signal SPI peripherals on the 8051 core, ADC behavior was validated at firmware logic level. Electrical accuracy of sensor interfaces is planned for validation on physical hardware.
Firmware behavior validated using Proteus simulation at system and logic level
UART used as the primary observation and debug interface to confirm system states
Motor control and global shutdown behavior verified through control signals and status indicators
Fault detection, latching, and recovery logic validated against defined thresholds
Sensor behavior emulated to exercise fault paths; ADC interface validated at firmware logic level
Simulation limitations identified and documented; full electrical validation planned on physical hardware
No dependency on physical PCB availability for firmware and system-level validation
Hardware Contains schematic, PCB, simulation files, and hardware documentation
Firmware Contains source code, configuration files, and firmware documentation
Each section includes its own detailed README.
YUKESH B.E. Electrical and Electronics Engineering
This project is intended for educational and non-commercial use. All materials are shared to support learning, experimentation, and academic review.
This project demonstrates a complete embedded system lifecycle - from concept and schematic design to firmware integration and simulation-based validation - following practices aligned with real-world engineering workflows.
No comments yet. Be the first to ask about this board.