Loading files…
a PCB designed to keep small connectors from failing when attached
i made this PCB because i don't want to make makeshifts anymore 💀
holds small (data) connectors of male side of XT30 2+2 so it cannot be slipped of connecting thus breaking the connector
Holds 16AWG max. cables on main connectors and 24AWG max. on small (data) connectors
3 boards per panel idk but this hopes to not make PCB makers mad
##Things listed below can be found above (in "Purchase assemblies")
Avoid pre-tinning the cable and PCB until the cable has fit through the board, unless you know what you're doing, otherwise you'll have a hard time solding the cable to the PCB.
fit cables to the PCB, make sure the cable going to the PCB is the one it connects, then solder cables to the board
put the connector to the PCB, make sure it fits
solder the connectors of XT30 2+2 and the PCB, Avoid heating it for too much as it will melt the connector and get the cable disconnected
No comments yet. Be the first to ask about this board.